The following setup is required for a setup which links Glofox to a door.
- a Windows PC to run the Gantner Software with Glofox. (The only access control software that we integrate with is Gantner). This has to be left on at all times. This should be a standalone device and we do not recommend that you use this computer for daily usage with Glofox. It should be a separate PC.
- Gantner Writer 6000F - you will use this device to assign cards/key tags to members. There is a new version of the product so make sure to order the 6000F. The tech specs are here.
- GAT Access 6100F - members will scan cards / key tags against this device in order to validate their membership. This device sends the signal to the turnstile to open. The tech specs are here.
- Door / Door Solenoid - the Gantner equipment will work with most door locks and solenoids. This is a piece of equipment that controls the opening and closing of the door when the member swipes the card. In this case, you should have a GAT Acess 6100f at the door which needs to feed back to the Windows PC via a cable. The tech sheet and setup is available here.
You must arrange for the door to be supplied by a third party supplier. It is up to your installer to confirm that the door ordered will work with Gantner.